Printer Friendly Page

Mounting –

Mount light securely; making sure bracket is square with vehicle. Tighten bolt on the bottom of the bracket to 50 ft/lbs.

Wiring –

All electronics are internal so there is no need to mount external electronics. Each light has a simple 2 wire hook up. Red being + 12v and black being – 12v. Lights should be wired to a switch through a relay with a maximum of 2 lights per relay, up to 12” bars, and 1 light per relay for larger, for optimum durability and performance. Each relay should be wired as follows:

86 – chassis ground

85 – 12v + trigger from switch

30 – 14 gauge 12+ from battery (minimum gauge is 14 for 2 lights)

87 – 14 gauge out to red (or white for 6504) wire on lights (max 2 lights per relay pack)

Duplicate relay packs can be wired for additional lights. Switch trigger can be jumped from relay to relay.

Remaining black wire on light should be chassis grounded; making sure grounding surface is cleaned down to metal, using a stainless steel bolt to secure grounding ring.

Adjust light –

A good reference point is at 20 ft; the top of the beam should be 3” down from center of light (with the light bar at dead center). Tighten light and enjoy.