HID-RELAY HARNESS for Side X Side vehicles

Relay - 30/40 Amp Relay with screw down terminal

Wire Gauge – 12 Gauge wire for main power and ground

Wire Length – Battery to relay (60 Inches)
Relay to Ballast 1 (12 Inches)
Relay to Ballast 2 (12 Inches)
Relay to 886 Plug (24 Inches)

Fuse – 30 amp fuse 6 Inches from battery on red wire

Battery Terminals – To accommodate a 10mm bolt on red and black wires

Wire Loom – Must be on all wires including main power wires

Plugs – This is a plug and play kit. All ballast, battery and trigger connections must come pre-installed on the harness.

Run power and ground to battery (it is ok if needed to lengthen leads at battery) mount relay under hood near the ballasts, unplug stock headlight power leads from both driver and passenger side, you can tie up passenger side it will not be used. Plug in relay powers to Vision X ballasts; plug driver side stock headlight power lead into relay harness (oval plug). Please make sure all wires are tied up and will not be exposed to the Off Road elements.

The kit is designed to only use the stock dash headlight switch to ignite the relay; this will allow all the direct power from the battery to go to the HID lights. Only some Arctic Cat and Polaris vehicles with 07 and newer computers may need this kit.

Thank you,

Vision X Off Road
800-994-4460