Why Vision X

QUALITY AS A PRIORITY

At Vision X, our products are constantly improving due to our rigorous product testing and standards we hold our products to.  Our lights have been tested using the most rigorous tests available, including by NASA in their TORR Chamber. In this test, the light was tested at 10K (-323 F) and put through zero atmosphere tests. Vision X lights are used by NASA because Vision X lighting solutions stand up to the harshest conditions. Vision X lighting also goes through Ingress Protection testing which tests for the ability to keep out water and dust. Isolux Testing (for lumens at particular distances), Vibration Testing, and Thermal testing also take place. Many Vision X lights have also gained CE Approval. Through all these tests Vision X ensures the best lights possible are on the market.

PRODUCT TESTING

Consumption

All products are put on a digital power meter to test that it is consuming the correct amount of power, checking for any electrical faults.

EMI

Products are tested in a sealed chamber to ensure that they don’t introduce RF noise into electronics/radios.

Submersion | AGING

Once products are assembled every product is run through a submersion (water dunk test), then placed onto an aging rack and powered up for 30 minutes to ensure proper operation.

Impact Rapid Temperature Change

Products are placed in a -40°C chamber for 30 minutes, and then placed in a 80°C chamber for an additional 30 minutes. Products are then run for 72 hours to ensure full operational status.

Photometric Isolux Beam Pattern

Lights are tested in the Goniophotometer to model the beam pattern and depict the overall light output.

High Temperature & High Humidity

Products are placed in a 60°C, 94% humidity chamber and left operational for 72 hours. Afterwards, products are inspected for moisture, water drops, damaged LEDs, flickering LEDs, and more.

Ingress High Pressure IP69K

Products are sprayed from close distances with 80~100 BAR water pressure to verify the Ingress Protection rating, ensuring they are sealed properly.

Vibration 15.6 Grms Rating

Products are placed on the vibration shock table with a vibration range of 25.6G for 4 hours to test that they can withstand the rated vibration standard. Products tested at 60 Grms are performed off-site.

Long Term Durability

Products are then switched on and off 20,000 times repeatedly to ensure that they remain functional after all testing